ESL5322LOEN Dishwasher User Manual
How to set the water softenerlevelMake sure the appliance is in user mode.1. Press .• The indicators , and are off.• The indicator still flashes
During the drying phase, thedoor opens automaticallyand remains ajar.CAUTION!Do not try to close theappliance door within 2minutes after automaticopen
Every time isactivated, XtraDry is off andneeds to be chosenmanually.How to activate XtraDryPress simultaneously and .The indicator is on.The d
8.2 How to fill the rinse aiddispenserABDCMAX1234+-ABDCCAUTION!Only use rinse aidspecifically designed fordishwashers.1. Press the release button (D)
2030BA DC1. Press the release button (B) to openthe lid (C).2. Put the detergent, in powder ortablets, in the compartment (A).3. If the programme has
Press and hold simultaneously and until the appliance is inprogramme selection mode.Cancelling the programmePress and hold simultaneously and unti
3. Start the shortest programme with arinsing phase. Do not add detergentand do not load the baskets.4. When the programme is completed,adjust the wat
1. Turn the filter (B) counterclockwiseand remove it.2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A).4. Wash the filters.5.
• If you regularly use short durationprogrammes, these can leavedeposits of grease and limescaleinside the appliance. To prevent this,we recommend to
Problem and alarm code Possible cause and solutionThe anti-flood device is on.The display shows .• Close the water tap and contact an Authorised Serv
CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...
12.1 The washing and drying results are not satisfactoryProblem Possible cause and solutionPoor washing results. • Refer to "Daily use", &qu
Problem Possible cause and solutionThere are residues of deter‐gent in the dispenser at theend of the programme.• The detergent tablet got stuck in th
Power consumption Left-on mode (W) 5.0Off-mode (W) 0.501) Refer to the rating plate for other values.2) If the hot water comes from alternative source
ENHazardous substancesParts Name Pb Hg Cd Cr6+ PBBs PBDEsCabinetXTubSump & hydraulics (including pumps, heater & sensors)XSoftener & inner
www.electrolux.com/shop156929010-A-102018
1. SAFETY INFORMATIONBefore the installation and use of the appliance, carefullyread the supplied instructions. The manufacturer is notresponsible f
• The operating water pressure (minimum andmaximum) must be between 0.5 (0.05) / 8 (0.8) bar(MPa)• Obey the maximum number of 13 place settings.• If t
• Connect the mains plug to the mainssocket only at the end of theinstallation. Make sure that there isaccess to the mains plug after theinstallation.
3. PRODUCT DESCRIPTION437 9 8 105611 121Upper spray arm2Lower spray arm3Filters4Rating plate5Salt container6Air vent7Rinse aid dispenser8Det
4. CONTROL PANEL1 24351On/off button2Display3Delay button4Programme buttons5Indicators4.1 IndicatorsIndicator DescriptionXtraDry indicator.Rinse aid i
Programme Degree of soilType of loadProgramme phases Options 4)• All • Prewash 1) With this programme you have the most efficient use of water and en
As the appliance stores the savedsettings, there is no need to configureit before every cycle.How to set the programmeselection modeThe appliance is i
Comments to this Manuals