Electrolux EJN2301AOW User Manual download pdf (Page 29)

Problem Possible cause Solution

The lamp is defective. Refer to "Replacing the

lamp".

The compressor operates

continually.

Temperature is set incor‐

rectly.

Refer to "Operation" chap‐

ter.

Many food products to be

frozen were put in at the

same time.

Wait some hours and then

check the temperature

again.

The room temperature is

too high.

Refer to climate class chart

on the rating plate.

Food products placed in

the appliance were too

warm.

Allow food products to cool

to room temperature be‐

fore storing.

There is too much frost

and ice.

The door is not closed cor‐

rectly or the gasket is de‐

formed/dirty.

Refer to "Closing the door".

The water drainage plug is

not correctly positioned.

Position the water drain‐

age plug in the correct

way.

Food products are not

wrapped properly.

Wrap the food products

better.

Temperature is set incor‐

rectly.

Refer to "Operation" chap‐

ter.

Water flows on the rear

plate of the refrigerator.

During the automatic de‐

frosting process, frost

melts on the rear plate.

This is correct.

Water flows into the refrig‐

erator.

The water outlet is clog‐

ged.

Clean the water outlet.

Food products prevent that

water flows into the water

collector.

Make sure that food prod‐

ucts do not touch the rear

plate.

Water flows on the floor. The melting water outlet is

not connected to the evap‐

orative tray above the com‐

pressor.

Attach the melting water

outlet to the evaporative

tray.

The temperature in the ap‐

pliance is too low/too high.

The temperature regulator

is not set correctly.

Set a higher/lower temper‐

ature.

The door is not closed cor‐

rectly.

Refer to "Closing the door".

ENGLISH 29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

Comments to this Manuals

No comments

Electrolux EJN2301AOW User Manual Page 29

Comments to this Manuals

Related products and manuals for Fridge-freezers Electrolux EJN2301AOW