Electrolux ELITE 4230x/42 cc Service Manual download pdf (Page 54)

Fitted Equipment

1. If applicable, turn off the gas operation.

2. Set the 240V rocker switch (B) to ‘O’ and

the 12V rocker switch (A) to 1.

Regulating the temperature

Once the refrigerator has been started it will

take a few hours to become cold.

On 240V operation the refrigerator is

controlled by a thermostat and the

thermostat knob (C) should be set at 3. If a

colder temperature is required, set the

thermostat to a higher number and vice

versa.

On LP gas operation the refrigerator

temperature is regulated by the gas control

knob (D). If the ambient temperature is above

25°C and/or the door of the refrigerator is

frequently opened, the knob should be set in

the ‘max’ position. Below 25°C, the knob

should be set at ‘mid’ and below 10°C at

‘min’ to avoid temperatures below freezing in

the main compartment.

MODEL RM4271

Two rocker switches are used to select the

electric power supply, one for 240V (B) and

one for 12V (A) (See Fig. B).

Refrigerator temperature is controlled by a

thermostat knob (C) when the refrigerator

runs on 240V.

The gas supply is turned ON/OFF by means

of the knob (D). When lighting the gas, the

knob must be pressed as explained in LP

Gas Operation.

Refrigerator temperature is controlled by a

thermostat (E) when the refrigerator runs on

LP gas. Please note that the thermostat has

no ‘OFF’ position.

The gas flame is electronically lit, monitored

and re-lit if necessary. For this, the toggle

switch (F) should be ‘ON’ during gas

operation.

STARTING THE REFRIGERATOR

LP Gas Operation

Before you start gas operation:

1. Open the shut-off valve of the gas bottle

(check that there is enough gas). Open

any on-board shut-off valve.

2. Check that the switches for mains and

12V operation are off.

3. Turn on gas supply by pressing knob (D)

and turning it to the flame position.

4. Set the thermostat knob (E) to the highest

setting.

5. Turn on switch (F). A light in the switch

should now start to flash, indicating that

sparks are being generated at the burner.

6. Press button (D). This opens the flame

failure device and allows gas to flow to

the burner.

7. When the flame ignites, the sparking

stops automatically and the switch stops

flashing.

8. Keep the knob (D) pressed for a further 10

to 15 seconds to activate the flame failure

device, then release it.

51

Fig. B Control Panel - RM4271

C D E

A

B F

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 110 111

Comments to this Manuals

No comments