Fitted Equipment
The gas flame is electronically lit, monitored
and re-lit if necessary. For this, the toggle
switch (E) should be ‘ON’ during gas
operation.
The RM4291 is fitted with an internal light
which is operated by the door.
STARTING THE REFRIGERATOR
LP Gas Operation
Before you start gas operation:
1. Open the shut-off valve of the gas bottle
(check that there is enough gas). Open
any on-board shut-off valve.
2. Check that the switches for mains and
12V operation are OFF.
3. Turn on gas supply by pressing knob (D)
and turning it to the highest flame
position.
4. Press ON switch (E). A light in the switch
should now start to flash, indicating that
sparks are being generated at the burner.
5. When the flame ignites, the sparking
stops automatically and the switch stops
flashing.
6. Keep the knob (D) pressed for a further
10 to 15 seconds to activate the flame
failure device, then release it.
7. To terminate gas operation turn knob (D)
to the ‘•’ position and put switch (E) to
the OFF position.
240V Operation
1. Turn off gas or 12V operation when
applicable.
2. Turn the knob (C) of the thermostat to its
highest (coldest) position.
3. Set switch (B) to position I. The switch
will light up green when the power supply
is connected.
12V Operation
Only operate your refrigerator on 12V when
the engine of your vehicle is running. Install
through a relay, otherwise your battery will
soon be discharged.
Note: Before operating the refrigerator on
12V, it should be pre-cooled, together with
its contents, by running it on bottled gas or
240V for a few hours before changing over
to 12V and starting on a journey.
1. If applicable turn off the gas operation.
2. Set the 12V rocker switch (A) to I. The
switch will light up red when the power
supply is connected.
REGULATING THE TEMPERATURE
The position numbers refer to Fig. A.
Once the refrigerator has been started it will
take a few hours to become cold.
On 240V operation the refrigerator is
controlled by a thermostat and the
thermostat knob (C) should be set at 3-5.
If a lower (colder) temperature is desired,
set the thermostat to a higher figure.
On LP gas operation the refrigerator
temperature is regulated by the gas
thermostat knob (D), which should be set at
the medium ‘flame’ position. If a lower
(colder) temperature is desired, set the
thermostat to the larger ‘flame’ position.
On 12V operation the refrigerator works
continuously.
WINTER OPERATION (ALL MODELS)
Please check that ventilation grilles or the
flue outlet are not blocked.
Ventilation grille covers are available from
Electrolux and can be fitted to protect the
unit against very cold air. These covers
should be fitted when the temperature is
below 10°C and when the caravan is laid
up during winter months.
53
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals