Electrolux Beam Alliance User Manual

BEAM AllianceOperation Manual

102.4 HEPA Filter MaintenanceWe recommend changing the HEPA  lter after the dirt bucket has been emptied three times, or after being used for one yea

114.0 INSTRUCTIONS: BEAM ALLIANCE LED/LCD SCREENS4.1 Power Button The Power symbol on the power unit screen or button can turn the unit ON/OFF. The

124.5 Empty Bucket Indicator (optional feature on select units)For every 25 hours of use (approximately 6 months) the empty bucket indicator icon will

134.8 Motor Fault IndicatorsIf there is a system fault or malfunction with your power unit, the fan blade icon will  ash with an exclamation icon. I

145.0 INSTRUCTIONS FOR BEAM ALLIANCE HOSE HANDLENOTE: The BEAM Alliance hose and hose handle will only function with a BEAM Alliance central vacuum sy

156.0 SERVICE INFORMATIONThe instructions in this booklet serve as a guide for routine operation and maintenance. For more information, contact your l

16© 2013 Electrolux Home Care Products Ltd. #87237Sold and serviced by:For additional product information visit www.beam.com

2TABLE OF CONTENTSImportant Safeguards 3Grounding/Earthing Instructions 4General Information 51.0 Installation 5 1

3IMPORTANT SAFEGUARDSWhen using an electronic appliance, basic safety precautions should always be followed, including those listed below.READ ALL INS

4GROUNDING/EARTHING INSTRUCTIONSWaste of Electrical and Electrical Equipment (WEEE). The symbol on the product or on its packaging indicates that thi

5GENERAL INFORMATION1.0 INSTALLATION 1.1 PlanningIf your home already has a system of plastic pipes and inlet valves, you are ready to install the pow

6Before hanging the power unit on the wall ensure the intake  ange on the power unit is positioned in the correct direction (see section 1.4); muffle

71.5 Muffler Installation1. To install the muffler on the power unit, connect one end of the short 90° elbow to the muffler as indicated in Figure 5.

82. Secure both the 90° elbow and HEPA  lter to the back of the power unit using the second Torx 20 screw provided. 3. Insert the HEPA  lter with

9• The central vacuum system can also be turned on/tested by pressing the power button on the power unit.• Check each inlet valve for air leaks. •