Electrolux Beam Alliance User Manual download pdf (Page 6)

Before hanging the power unit on the wall ensure the intake

 ange on the power unit is positioned in the correct direction

(see section 1.4); muffler is installed correctly (see section

1.5), optional HEPA  lter is installed correctly (see section

1.6); and optional bag adaptor is installed correctly (see

section 1.8).

Strip the low-voltage wires that were installed with the

main trunk line. Connect the wires to the spring-loaded

connectors on the back of the power unit (refer to Figure 3).

Hang the power unit on the bracket. Connect the main tube

line to the intake  ange of the vacuum with the connector

and clamp provided.

DO NOT glue the main tube line to the power unit so that

the power unit may be removed for future maintenance or

service.

WARNING

• WARNING: Do not block the exhaust pipe. Lack of ventilation will cause the motor to

overheat.

• WARNING: Do not locate the power unit in a high temperature area where it is

inaccessible for example, an attic or crawl space.

1.4 Intake Flange

Your power unit has been designed for either a left or right pipe intake. If the pipe from your house is

located on the right side of the power unit, you will need to change the direction of the intake  ange.

To do this, remove the two Torx 20 screws located on the intake  ange and turn the intake  ange 180°.

Secure the intake  ange with the same two Torx 20 screws previously removed (refer to Figure 4).

Figure 3

Figure 4

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Electrolux Beam Alliance User Manual Page 6