Electrolux EW1025F User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 15
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
30
INSTALLATION
Unpacking
All transit bolts and packing must be removed before
using the machine.
You are advised to keep all packing for re-use in case
you move house and the machine has to be transpor-
ted again.
Proceed as follows:
Using a spanner remove
the screw on the right at
the rear of the machine.
Carefully lay the machine
on its back making sure
that the hoses are not
squashed.
Place one of the polysty-
rene angle packings
between the machine
and bottom.
Remove the polystyrene block from underneath the
machine.
Release the two polythene bags by removing the
adhesive strip.
Carefully remove the right polythene bag (1) by pull-
ing it towards the centre of the machine. Repeat the
operation for the left polythene bag (2).
Set the machine upright and unscrew the two remai-
ning rear screws.
Slide out the 3 plastic spacers and plug the 3 holes
with the 3 plastic plugs which you can find on the
back of the machine.
Positioning
Position the machine on a firm level surface.
The machine must not touch the wall or other furni-
ture.
It is assumed that the tap, drainage point and socket
are within easy reach of the machine hoses and
power supply cable. If not, you are advised to call
your fitter in order to move the tap and/or drainage
point and/or socket.
Water inlet
Connect the water inlet
hose to a tap with a
3
/
4
"
gas thread spout after
fitting the filter supplied
with the machine.
The other end of the
inlet hose connected to
the machine can be tur-
ned in any direction.
Simply loosen the fitting,
rotate the hose and reti-
ghten.
The inlet hose must not
be extended. If it is too
short and you do not
wish to move the tap, replace it completely with a lon-
ger high pressure hose specifically designed to solve
problems of this type.
P0255
P0234
P0233
2
1
P0003
P0021
P0256
P0020
P0023
Page view 3
1 2 3 4 5 ... 15

Comments to this Manuals

No comments