Electrolux EOB67200X User Manual Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
2. Pull the door trim to the front to remove
it.
3. Hold the door glass panels on their top
edge one by one and pull them up-
wards out of the guide
4. Clean the door glass panels.
To install panels follow the procedure in
reverse. Insert the smaller panel first,
then the larger.
WHAT TO DO IF…
Warning! Refer to "Safety information"
chapter.
Problem Possible cause Solution
The oven does not heat up The appliance is switched off Switch on the appliance
The oven does not heat up The clock is not set Set the clock. Refer to "Setting
the clock"
The oven does not heat up The necessary settings are not
set
Make sure, the settings are
correct
The oven does not heat up The automatic cut-out is
switched on
Refer to "Automatic cut-out"
The oven does not heat up The fuse is released Make sure, if the fuse is the
cause for the malfunction. If the
fuse releases again and again,
refer to an authorized electri-
cian
The oven lamp does not oper-
ate
The oven lamp is defective Replace the oven lamp
The display shows F11 There is a short circuit of the
meat probe
The meat probe plug is not
correctly installed into the
meat probe socket
Insert the meat probe plug as
far as possible
The display shows an error
code that is not in this list
There is an electronic fault Switch off the appliance with
the house fuse or the safety
switch in the fuse box and
switch it on again
If the display shows the error
code again, refer to the Cus-
tomer Care Department
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the oven cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
24 electrolux
Page view 23
1 2 ... 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments