Electrolux ENL60810X User Manual download pdf (Page 7)

electrolux side by side refrigeration user manual 7

Ice and water models

The water connection to your ice and water product should

only be done by a licensed refrigeration mechanic, plumber or

electrician. All relevant information regarding the water connection

is detailed in the water kit provided with your product for use by

the professional installer only.

The automatic ice and water dispenser needs a drinkable water

supply with a pressure of:

• minimum 206 kPa (30 psi, 2.11 kgf/cm2)

• maximum 689 kPa (100 psi, 7.04 kgf/cm2)

In some areas water pressure is signicantly higher due to local

conditions. In such areas a pressure reducing valve must be used.

Ensure your plumber or installer checks your local water pressure

when installing your refrigerator.

If you are using your refrigerator for the rst time, or if you have not

used the dispenser for some time:

• discard the rst seven or eight cups of water

• discard any ice that the ice maker produces in the

rst 24 hours (contaminants could have settled in the water

pipes)

(see page 14 for more information)

The water tap can be anywhere and there is no limit to the amount

of pipe between the tap and the refrigerator, however some points

to note are:

1. It is better to have the tap accessible without having to roll

the refrigerator forward, so we recommend putting it outside

the cavity as shown by the taps in the diagram below.

2. It is recommended, but not essential that the height

of the tap should be 400mm from the ground.

3. If the refrigerator is required to be pulled forward for cleaning,

the water pipe may need to be removed from the tap.

Adjusting door alignment

Each door is independently adjustable in the vertical direction by

turning the adjustable bolts under the hinges using the spanner

provided.

Large plastic roller nut

Front Roller

Adjusting Bolt

The doors can be adjusted up or down. Depending on the amount

of adjustment required it may be sufcient to adjust only one door.

(see Diagrams below)

Note: When the height of the rollers and adjusting bolts

are correctly adjusted the refrigerator will stand ﬁrmly on

the ﬂoor and the doors will be in line with one another.

Spanner

Internal packaging

Please remove any internal packaging material before use.

There may be a strip of foam taped to the door bins. There

will also be tape applied to several parts such as the locker.

There may be a sheet of protective lm attached to the

multi-ow duct at the rear of the refrigerator section, please

remove this prior to operation as it may obstruct airow.

Protective lm may also be on the display tted to the

control housing.

Please remove all internal packaging before use. Any glue or

tape residue or the like should be removed with a solution of mild

detergent and water.

Door bins

model 610L side by side shown

Door binsMulti-flow duct

1 2 3 4 5 6 7 8 9 10 11 12 ... 83 84

Comments to this Manuals

No comments

Electrolux ENL60810X User Manual Page 7

Comments to this Manuals

Related products and manuals for Fridges Electrolux ENL60810X