Electrolux ER7825B User Manual download pdf (Page 5)

OPERATION

Before using

Remove all securing tapes. Wash inside the

appliance with lukewarm water and bicarbonate of

soda (5 ml to 0.5 litre of water).

Do not use soap or detergent as the smell may

linger. Dry thoroughly.

Setting the temperature

The temperature inside the refrigerator is regulated

by a thermostat with 6 temperature positions and an

ÒOFFÓ (O) position.

Position 1 = minimum coldness

Position 6 = maximum coldness

Turn the thermostat dial to the required position.

The intermediate position is usually the most

suitable (3-4).

The thermostat setting can vary as the temperature

inside the refrigeration compartment depends on the

following factors:

Ð room temperature

Ð how often the door is opened

Ð how much food is stored

Ð position of the appliance

Important

If the fridge is not defrosting correctly, it is possible

that because a very low temperature has been

selected, the motor is working continuously, which

prevents the defrost cycle from operating.

To ensure correct defrosting, a lower number should

be selected on the thermostat and you should notice

that the motor cuts out from time to time, which is

correct.

If you wish to return to a lower temperature, turn the

thermostat to a higher number, however you should

turn the setting lower occasionally to allow automatic

defrosting.

Low Ambient Temperature Switch

To ensure that the appliance is working efficiently

when the room temperature drops below 16¡C, the

switch mounted next to the thermostat control should

be switched on.

The freezer compartment

The four-star freezer compartment is suitable for

storage of commercially frozen food and for freezing

fresh foods.

Freezing fresh food

When freezing large amounts of fresh food turn the

thermostat to maximum approximately 1 hour prior to

freezing.

When the food is frozen return to the normal

position.

In any 24 hours you can freeze up to 10 kg.

Place food to be frozen in the upper drawer of the

freezer as this is the coldest part.

Important

In the event of a power cut do not open the door.

The food in the freezer will not be affected if the

power cut is short and if the freezer is full. Should

the food begin to thaw, it must be consumed quickly

and must not be re-frozen .

No damage can be caused by leaving the switch in

this position for any period of time (see page 11 Low

ambient operation). However should the temperature

rise above 16¡C remember to turn the switch off

again.

A - Low Ambient Switch

D710

Door reversal directions

1. Disconnect from the electricity supply.

2. Remove all loose items, including food, store food in

a cool place.

3. Gently lay the fridge/freezer on its back with the top

held away from the floor by 5-8 cm (2-3 inches) of

packing;

4. Remove the feet (B)

5. Remove bottom hinge (A).

6. Remove the freezer door by releasing it from the

middle hinge (H).

7. Unscrew the middle hinge.

8. Slide out the fridge door from pin (G), unscrew the

latter and then screw it down into the hinge-blade

provided on the opposite side, after having removed

the small plugs (I) which should then be fitted on the

opposite side.

9. Refit the fridge door and replace the middle hinge to

the left hand side.

10.Replace the door and bottom hinge (A) on the

opposite side.

11.Refit the feet (B) on the opposite side.

Attention

After completion of the door reversing operation, check

that the door gasket adheres to the cabinet. If the

ambient temperature is cold (i.e. in Winter), the gasket

may not fit perfectly to the cabinet. In that case, wait for

the natural fitting of the gasket or accelerate this

process by heating up the part involved with a normal

hairdryer on a low setting.

D715

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Electrolux ER7825B User Manual Page 5

Comments to this Manuals

Related products and manuals for Fridges Electrolux ER7825B