Electrics
Changing the Exit Delay Time
1. Press "F", press "2".
2. Enter your personal code.
3. Enter the new exit delay as 3 digits, i.e.
20 seconds is entered 020, 1 minute is
100. (Please note the maximum time
allowed is 4 minutes i.e. 400).
4. Press "F".
5. This operation can be cancelled at any
time before step 3 by press "C".
Changing the Siren-on Time
1. Press "F", press "3".
2. Enter your personal code.
3. Enter the preferred time as 3 digits, i.e.
2 minutes is entered 200. (Please note
the maximum time allowed is 4 minutes,
i.e. 400).
4. Press "F".
5. This operation can be cancelled at any
time before step 3 by pressing "C".
Setting up the Tilt Sensor
The tilt sensor is not adjustable and requires
the caravan to be reasonably level. If the Tilt
Sensor is active, one of the Tilt Sensor
Indicators will illuminate on the keypad.
Adjust the level of the van until the light goes
off.
Arming the System
If you are in the PIR's sight, then it is
possible that when arming the system, any
movement detected by the PIR will deselect
the PIR channel. To avoid deselecting the
PIR accidentally please ensure that you
remain perfectly still when arming the
system. This is very important when the
keypad is sited within the PIR coverage area.
1. Enter the personal code, the indicators
for all available sensors will light (IF a
sensor indicator fails to light, see
"TROUBLESHOOTING").
2. To Disable any sensors not required,
press the relevant key, i.e. 1 for PIR, 2 for
tilt, 3 for tow sensor. Repeated pressing
will select (light comes on) and disable
(light goes off) the relevant sensor.
3. Press "F". The exit delay will begin, 1
pulse per second.
4. 2 short bursts on the siren will be heard
at the end of the exit delay. This confirms
the system is armed.
5. This operation can be cancelled at any
time before step 4 by pressing "C".
Disarming the System
1. Enter your personal code. (This is the
only way to disarm the system).
2. If the system has been inactive all
indicators will flash twice on the keypad.
3. If a sensor has been activated then the
corresponding light on the keypad will
flash five times. However, if the system
had been continuously active for 20
minutes or more (and subsequently reset)
there will be a random flashing of
indicators proceeding the display of the
sensor(s) responsible.
Note: When the siren is active there is no
limit on key entries. When the siren is
inactive a maximum of 16 key entries are
allowed. If 16 key entries are exceeded then
the system will not accept any more entries
until the siren is activated.
Memory Recall
This enables the user to tell if any sensors
were active during the previous armed state.
1. Press "F", press "5", watch the
indicators.
2. If all indicators flash twice the system has
been quiet.
3. If any indicator flashes 5 times, the
corresponding sensor has been active.
4. A random flashing of indicators followed
by 5 flashes for sensor(s) means that the
system has had to reset (i.e. disarm itself)
due to the siren being active for 20
minutes.
43
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals