Electrolux EWS106430W User Manual download pdf (Page 20)

Emergency emptying out

If the water is not discharged, proceed as

follows to empty out the machine:

1. pull out the plug from the power socket;

2. close the water tap;

3. if necessary, wait until the water has

cooled down;

4. open the pump door;

5. place a bowl on the floor. Remove the

emergency emptying cap from the filter.

The water should drain by gravity into the

bowl. When the bowl is full, refit the cap

into the filter. Empty the bowl. Repeat the

procedure until water stops flowing out;

6. clean the pump if necessary as previously

described;

7. screw the pump again and close the

door.

Frost precautions

If the machine is installed in a place where the

temperature could drop below 0°C, proceed

as follows:

1. Pull out the plug from the power socket.

2. Turn off the water tap.

3. Unscrew the inlet hose.

4. Place the end of the inlet hose in a bowl

placed on the floor, open the emergency

emptying cup of the filter and let water

drain out.

5. Refit the emergency emptying cap into

the filter and screw the water inlet hose

back.

6. When you intend to start the machine up

again, make sure that the room temper-

ature is above 0°C.

What to do if...

Certain problems are due to lack of simple

maintenance or oversights, which can be

solved easily without calling out an engineer.

Before contacting your local Service Centre,

please carry out the checks listed below.

During machine operation it is possible that

the red pilot light of button 8 blinks, one of

the following alarm codes appears on the

display and some acoustic signals sound ev-

ery 20 seconds to indicate that the machine

is not working:

•

: problem with the water supply.

•

: problem with the water draining.

•

: door open.

Once the problem has been eliminated,

press the button 8 to restart the programme.

If after all checks, the problem persists, con-

tact your local Service Centre.

Problem Possible cause/Solution

The machine does not start:

The door has not been closed. E40

•Close the door firmly.

The plug is not properly inserted in the power socket.

• Insert the plug into the power socket.

There is no power at the socket.

• Please check your domestic electrical installation.

The main fuse has blown.

• Replace the fuse.

The selector dial is not correctly positioned and the button 8 has not

been pressed.

• Please turn the selector dial and press the button 8 again.

The delay start has been selected.

• If the laundry are to be washed immediately, cancel the delay start.

The Child Safety Lock has been activated.

• Deactivate the Child Safety Lock.

20 electrolux

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Electrolux EWS106430W User Manual Page 20

Comments to this Manuals

Related products and manuals for Washing machines Electrolux EWS106430W