Electrolux SBB800S-1 Installation Manual download pdf (Page 35)

Connecting the pump control wire

1. Leave enough slack so that the pump control

wires will stay connected if the unit is removed

from the wall.

2. Remove the front cover of the heater (4 screws).

3. Cut off the connector at the end of the pump control

wires.

4. Wire the pump control wires through the wiring

throughway and connect them to the wiring inside

the pump (this will be the power supply for the pump,

do not also connect 120VAC to the pump).

If a large pump is being used (greater than 85W) use

the voltage from these wires as the signal to close a

normally open relay through which 120VAC will be

supplied directly from a wall circuit to the pump.

5. Replace the front cover.

Pump Wiring

* This feature is not available when using the Quick

Connect Multi System feature.

Relay connection with larger pumps (>85 W)

1. Locate and prepare the pump control wires as described above.

2. Choose a suitable installation location for the relay where it will be protected from moisture.

3. Connect the pump control wires from the heater to the signal input on the relay.

4. Cut one of the electrical supply leads and wire it across the open terminals of the relay.

5. Secure all connections and replace the front cover of the heater.

Circulation Pump

120VAC

Relay (ex. Omron G7L2ABUBJCBAC120)

Connect to Pump Control

Wires in Unit

PUMP

Crimping Terminal

Wiring

Throughway

Supplies Power for

Circulating Pump

(Use a Relay for

Larger Pumps)

Pump Control

Wire Tag

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 83 84

No comments

Electrolux SBB800S-1 Installation Manual Page 35