Electrolux ESL6380RO User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 68
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
Stains and dry water drops on
glasses and dishes
The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
The quality of the detergent can be the
cause.
Dishes are wet
The programme is without a drying
phase or with a low temperature drying
phase.
The rinse aid dispenser is empty.
The quality of the rinse aid can be the
cause.
The quality of the combi detergent tab-
lets can be the cause. Try a different
brand or activate the rinse aid dispens-
er and use rinse aid together with the
combi detergent tablets.
Refer to ‘HINTS AND TIPS’ for
other possible causes.
10.2 How to activate the rinse
aid dispenser
The activation of the rinse aid dispenser
can occur only with the Multitab option
activated.
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to “Set-
ting and starting a programme”.
2. Press and hold, at the same time,
Program and MyFavourite until the
indicators of Delay, Program and My-
Favourite start to flash.
3.
Press Program.
The indicators of Delay and MyFa-
vourite go off.
The indicator of Program continues
to flash.
The display shows the current set-
ting.
Rinse aid dispenser off.
Rinse aid dispenser on.
4. Press Program to change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
6. Adjust the released quantity of rinse
aid.
7.
Fill the rinse aid dispenser.
11. TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 596 / 818 - 898 / 550
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
Capacity Place settings 12
Power consumption Left-on mode 0.10 W
Off-mode 0.10 W
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
2)
If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
16
www.electrolux.com
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Comments to this Manuals

No comments