Electrolux 137018200 A Use and Care Guide Page 1

Installation InstructionsElectrolux Front-Load Gas & Electric DryerInstrucciones de InstalacionSecadora eléctrica y a gas de carga frontal Electro

10Installation Instructions WARNINGELECTRICALSHOCKHAZARDThisapplianceMUSTbeproperlygrounded.•Electrical shock can result if the dryer i

11Installation Instructions WARNINGELECTRICALSHOCKHAZARDImproper connection of the equipment grounding conductor can result in a risk of elec

12Installation InstructionsElectrical connection (non-Canada) - 3 wire cordTurn off power supply to outlet. 1. Remove the screw securing the terminal

134-wire receptacle(NEMAtype14-30R)Installation Instructions Electrical connection (non-Canada) - 4 wire cordTurn off power supply to outlet. 1. Re

14Installation InstructionsGas connectionRemove the shipping cap from gas pipe at the 1. rear of the dryer. IMPORTANTThe supply line must be equ

15Water connection (Steam Model only)Installation Instructions Turn off COLD water supply to washer,1. Remove COLD inlet hose from COLD water 2. suppl

16Installation InstructionsWater connection, con’t (Steam Model only)WATER INLET ON DRYERDIRECT CONNECTION OR WITH EXTENSIONCOLD WATER SUPPLY HOSE TO

17General installation NOTEA wiring diagram and technical data sheet are located inside the dryer console.Grounding typewall receptaclePower cor

18Installation InstructionsPerforming Installation CycleIf your dryer has this console:If your dryer has this console:Empty the dryer drum.1. After yo

19Reversing Door 1 Besureyouhaveadequateswingareabeforereversingdoor. 2 You will need a screw driver with a #2 square bit. 3 Protecta

2Finding InformationPlease read and save this guideThank you for choosing Electrolux, the new premium brand in home appliances. These Installation Ins

20Reversing DoorC)ReversingHardwareonFrontPanel 1 Remove 2 short, course-thread, panhead screws from striker and 2 plastic hole plugs. 2 Rot

21Reversing DoorE)RemovingLatchIndicatorF)RemovingHolePlug 1 Insert flat blade screwdriver into open slot of latch indicator. 2 Gentlypryup

22Reversing DoorG)ReinsertingLatchIndicator 1 Rotate the latch indicator and move it to the opposite hole in the door.insert indicator through sl

23Reversing DoorI)ReattachingLatchPlate 1 Rotate latch plate and move to opposite side of door above indicator. 2 Reattach with 2 long, course-

24 3 Rotate and move trim ring cover plate to opposite opening in trim and reinsert.M)ReinstallingTrimRing 1 Close door. 2 Orienttrimso12

25OptionsReplacement parts: 1-877-4ELECTROLUX (1-877-435-3287)If replacements parts are needed for your dryer, contact the source where you purchased

26Notes

3SafetyImportant Safety InstructionsRecognize safety symbols, words and labelsSafety items throughout this manual are labeled withaWARNINGorCAUTIO

4Installation Requirements IMPORTANTThis dryer is internally grounded to neutral unless it wasmanufacturedforsaleinCanada.Groundingthroug

5Installation Requirements WARNINGFIREHAZARDFailure to follow these instructions can create excessivedryingtimesandrehazards. WARNI

6Installation Requirements WARNINGFIREHAZARDExceedingthelengthofductpipeornumberofelbowsallowedinthe“MAXIMUMLENGTH”charts can ca

7Installation Requirements WARNINGEXPLOSIONHAZARDDo not install the dryer where gasoline or other flammables are kept or stored. If the dryer is

8MINIMUMINSTALLATIONCLEARANCES-Inches(cm)SIDES REAR TOP FRONT Alcove 0”(0cm) 0”(0cm)* 0”(0cm) n/a Under- Counter0”(0cm) 0”(0cm)* 0”(0

9Installation Requirements38.00”(96.5cm)16.25”(41.5cm)18.25”(46.5cm)53.00”(134.5cm)1.4”(3.5cm)3.75”(9.5cm)13.50”(34.5cm)to center of rear vent3.40”(8.