Electrolux 137018200 A Use and Care Guide download pdf (Page 14)

Installation Instructions

Gas connection

Remove the shipping cap from gas pipe at the 1.

rear of the dryer.

IMPORTANT

The supply line must be equipped with an

approved manual shutoff valve. This valve

should be located in the same room as the dryer

and should be in a location that allows ease of

opening and closing. Do not block access to the

gas shutoff valve.

Connecta1/2inch(1.27cm)I.D.semi-rigidor2.

approved pipe from gas supply line to the 3/8

inch(0.96cm)pipelocatedonthebackofthe

dryer.Usea1/2inchto3/8inch(1.27cmto

0.96cm)reducerfortheconnection.Applyan

approved thread sealer that is resistant to the

corrosive action of liqueﬁed gases on all pipe

connections.

Open the shutoff valve in the gas supply line to 3.

allow gas to ﬂow through the pipe. Wait a few

minutes for gas to move through the gas line.

IMPORTANT

DONOTconnectthedryertoL.P.gasservice

withoutconvertingthegasvalve.AnL.P.

conversion kit must be installed by a qualiﬁed

gas technician.

WARNING

EXPLOSIONHAZARD

NEVER test for gas leaks with an open ﬂame.

All connections must be wrench-tightened

Flare

Union

Flare

Union

GAS FLOW

Manual

Shuto

Valve

Closed

Open

Flexible

Connector

Inlet Pipe on

Back of Dryer

elppiN

Shuto Valve -

Open position

to dryer

from gas supply

Check for gas system leaks with a manometer. 4.

If a manometer is not available, test all

connections by brushing on a soapy water

solution.

1 ... 13 14 15 ... 26

Comments to this Manuals

No comments

Electrolux 137018200 A Use and Care Guide Page 14

Comments to this Manuals

Related products and manuals for Electric laundry dryers Electrolux 137018200 A