Electrolux EDE57160W User Manual download pdf (Page 12)

12 electrolux use

Select the Start/Pause

Press this button to start the dryer after

having selected the programme and

the options. The relevant light will stop

flashing. If the door of the appliance or

the small door at the bottom is opened

while the programme is running, this

button must be pressed again after

closing the door in order to restart the

programme from the point at which it

was interrupted. In both cases the light

of the Start/Pause button flashes to

remind you that the start button needs

to be pressed again.

IInnddiiccaattoorr lliigghhttss

These lights indicate the following

functions:

““DDrryyiinngg”” lliigghhtt

This light indicates that the appliance is

in the drying phase.

““CCoooolliinngg”” lliigghhtt

This light indicates that the appliance is

in the cooling phase. At the end of

drying, there is a 10 minute cooling

phase to cool the laundry.

““EEnndd ooff pprrooggrraammmmee”” lliigghhtt

This light is on at the end of the cooling

phase, during the anti-creasing phase

and at the end of the programme.

““FFiilltteerr cclleeaanniinngg”” lliigghhtt

It comes on every 80 cycles to r

emind

you that the condenser must be

cleaned.

E.27

At the end of the programme

All drying programmes end with a 10

minute cooling phase.

If the laundry is not removed at the end

of the cycle, the dryer performs an

anti-creasing phase (duration: 30 min-

utes maximum).

If you do not remove the laundry, the

dryer will stop automatically at the end

of the anti-creasing phase.

Lights end and filter remain lit and the

buzzer sounds for 2 minutes.

Turn the programme selector dial to “0”;

all the lights go out. The appliance is

switched off.

Remove the laundry.

If you open and then close the door

before turning the selector dial to “0” all

the indicator lights come on.

AAfftteerr eeaacchh uussee

• Clean the filters.

Important!

If the drying programme has to be

stopped before it reaches the end, we

recommend that you turn the pro-

gramme selector dial to position Cooling

and wait until the end of this cooling

phase before removing the laundry. This

will avoid a build-up of heat inside the

appliance.To do this first turn the dial to

“

OO

” and then to Cooling and depress

Start button.

MMooddiiffyyiinngg tthhee pprrooggrraammmmee

To change a programme which is run-

ning, first cancel it by turning the pro-

gramme selector dial to “

OO

”. Select the

new programme and press the Start

button .

125989890.qxp 2007-07-18 09:32 Page 12

1 ... 11 12 13 ... 32

Comments to this Manuals

No comments