Electrolux EDE57160W User Manual download pdf (Page 26)

26 electrolux installation

Note that to avoid condensation

problems, it is essential that the dryer

be fitted with the flexible hose to carry

its “exhaust” at least beyond the

kitchen units; preferable outside the

kitchen.

In order to prevent the appliance from

overheating, it is important that the

steam exhaust is unobstructed.

Therefore, in case of a permanent hose

fitted to an exterior wall or ceiling, it

must be ensured an exhaust capacity

of at least 150 m3/h.

If the dryer is fitted next to kitchen

units, make sure that the vent hose is

not squashed. If the hose is partially

squashed, drying efficiency will be

reduced, resulting in longer drying

times and higher energy consumption.

If the hose is completely squashed, the

safety cut-outs with which the machine

is fitted may operate.

When operating the tumble dryer, the

room temperature must not be lower

than +5°C and higher than +35°C, as it

may affect the performance of the

appliance.

Stacking kit

A special stacking kit is available through

your dealer, to enable the mounting of

the dryer on top of a front loading

washing machine with cover’s depth

between 48 and 60 cm.

Read carefully the instructions supplied

with the kit.

P1107

Door reversal

To make it easier to load or unload the

laundry the door can be reversed.

This operation must be carried out by

qualified personnel.

Please contact the nearest Electrolux

Service Centre.

TThhiiss wwiillll bbee aa cchhaarrggeeaabbllee ooppttiioonn..

Electrical connection

Any electrical work required to install this

appliance should be carried out by a

qualified electrician or competent

person.

WARNING: THIS APPLIANCE MUST

BE EARTHED.

The manufacturer declines any

liability should this safety measure

not be observed.

Before switching on, make sure the

electricity supply voltage is the same as

that indicated on the appliance’s rating

plate. (See picture on page 5).

The appliance is supplied with a 13amp

plug fitted.

In the event of having to change the fuse

in the plug supplied, a 13amp ASTA

approved (BS1362) fuse must be used.

Should the plug need to be replaced for

any reason, proceed as described

below.

The wires in the mains lead are coloured

in accordance with the following code:

Green and Yellow - Earth

Blue - Neutral

Brown - Live

125986421_gb.qxp 2007-10-05 07:51 Page 26

1 ... 25 26 27 28 29 30 31

Comments to this Manuals

No comments