Electrolux EK14011LIBR C User Manual download pdf (Page 21)

Setting up

• Standard EN 378 specifies that the room in which you install

your appliance must have a volume of 1 m

per 8 g of R 600a

refrigerant used in the appliance, so as to avoid the formation of

inflammable gas/air mixtures in the room where the appliance

is located in the event of a leak in the refrigerant circuit. The

quantity of refrigerant used in your appliance is indicated on the

type plate on the inside of the appliance.

• Only use the appliance when it is installed.

• Do not cover ventilation open-

ings or grille.

Climate rating

The climate rating indicates the room tem-

perature at which the appliance may be

operated in order to achieve full refrigeration

performance.

The climate rating is indicated on the type

plate.

The position of the type plate is shown in the section entitled

Description of the appliance.

Climate rating Room temperature

SN +10°C to +32°C

N +16°C to +32°C

ST +16°C to +38°C

T +16°C to +43°C

SN-ST +10°C to +38°C

SN-T +10°C to +43°C

Do not operate the appliance outside the speci-

fied room temperature range.

Electrical connection

Only operate the appliance with alternating current (AC).

The permissible voltage and frequency are indicated on the type

plate. The position of the type plate is shown in the section entitled

Description of the appliance.

The socket must be properly earthed and protected by a fuse.

The tripping current of the fuse must be between 10 A and 16 A.

The socket must not be situated behind the appli-

ance and must be easily accessible.

Do not connect the appliance using an exten-

sion cable or extension socket.

Do not use stand-alone inverters (conversion

of direct current to alternating/three-phase cur-

rent) or energy-saving plugs. Risk of damage

to the electronic control system!

• Do not store explosives or sprays using combusti-

ble propellants such as butane, propane, pentane,

etc. in the appliance. Electrical components might

cause leaking gas to ignite. You may identify such

sprays by the printed contents or a flame symbol.

• Do not use electrical appliances inside the appli-

ance.

• The LED lamp is designed to illuminate the inte-

rior of the appliance. It is not suitable for lighting

a room.

Switching the appliance on and off

You are recommended to clean the interior of the appliance before

switching it on for the first time (see Cleaning).

Switching the appliance on

Connect the appliance to the mains - the appliance is switched on.

Switching the appliance off

Pull out the mains plug or set the temperature control to 0.

Important

When the temperature control is turned to 0, only the re-

frigeration system is switched off. Before cleaning, always

disconnect the appliance from the mains. Remove the plug.

Setting the temperature

Set the temperature inside the appliance

using the temperature control.

When the control is turned to max., the

temperature inside the appliance is at

its lowest.

Set the control between 0 and max. as required.

The middle control setting is recommended, then a middle tempera-

ture of approx. 5°C is established in the refrigerator compartment.

An average temperature of approx. –18°C is then established in

the freezer compartment.

Turn on switch C on the

temperature control housing

for operation at low room

temperatures os 18°C or

below. This guarantees the

necessary low temperatures

in the freezer compartment.

It is not necessary to turn on the switch at normal room tempera-

tures (above 18°C).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Electrolux EK14011LIBR C User Manual Page 21

Comments to this Manuals

Related products and manuals for Fridges Electrolux EK14011LIBR C