Electrolux EWF12853 User Manual download pdf (Page 17)

When the program is completed

and the door lock indicator “ ”

goes off, you can open the door.

17

When The Washing

Program Is Completed, But

There Is Water In The Drum

The drum turns regularly to prevent

the creases in the laundry.

You must drain the water to open the

door.

(Option “Rinse Hold” is used)

The indicator “Start/Pause” flashes to

remind you to drain the water.

-

-

-

5.10

The appliance stops automatically.

The acoustic signal will operate.

The display will show “ ”.

The indicator of the touchpad

Start/Pause goes off.

-

-

-

-

-

-

-

-

The door lock indicator “ ” goes off.

Remove the laundry from the

appliance. Make sure that the drum is

empty.

Keep the door partly open, to prevent

the mildew and odours.

Turn off the water tap.

5.9 At The End Of The Program

At the end of the program, the time

remaining can suddenly decrease

from 7 minutes or less to 0 due to the

overestimated total program time

during the load sensing phase. In

some cases (with perfectly balanced

load) the program time can be shorter

than the time estimated after the load

sensing phase is completed. This is a

normal behavior of the machine and

not a cause for concern as it does not

compromise its performance.

NOTE:

The door lock indicator “ ” is on.

The door stays locked.

1.

To drain the water:

Press the “Start/Pause ” touchpad.

The appliance drains the water and

spins with the maximum spin speed

for selected program.

Alternatively, before pressing the

“Start/Pause” touchpad, you can press

the “Spin ” touchpad to change the

spin speed. You can select “No Spin”,

if you want the machine to only drain

the water.

2.

turn the program selector knob to

the position “Off” to deactivate the

appliance.

3.

After approximately 18 hours, if you

do not press Start/Pause touchpad,

the appliance will drain and spin

automatically (except for “Wool”

program) .

All indicators and the display will

switch off.

The indicator of the touchpad

Start/Pause will flash slowly.

Press any touchpad to

reactivate the appliance.

AUTO Standby Mode

5.11

The AUTO Standby mode automati-

cally deactivates the appliance to

decrease the energy consumption

when:

You do not press any buttons for 5

minutes before you press

“Start/Pause”.

5 minutes after the washing program

ends, if you do not deactivate the

appliance, the energy saving

function activates.

Press any touchpad to

reactivate the appliance.

-

-

All indicators and the display will

switch off.

The indicator of the touchpad

Start/Pause will flash slowly.

-

-

Press any touchpad again to

show the last wash program.

Turn the selector knob to set a

new wash program.

-

-

-

Display will show the end of the

last wash.

-

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 99 100

Comments to this Manuals

No comments