Electrolux EN2400AOX User Manual Page 68

  • Download
  • Add to my manuals
  • Print
  • Page
    / 154
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 67
70 www.electrolux.com
Problem Possible cause Solution
The temperature in the
appliance is too high.
The Temperature regulator
may be set incorrectly.
Set a lower temperature.
The door is not
closed correctly.
Refer to "Closing the door".
The product temperature
is too high.
Let the product tem-
perature decrease to room
temperature before storage.
Many products are stored
at the same time.
Store less products
at the same time.
The temperature in the
refrigeration is too high.
There is no cold air circu-
lation in the appliance.
Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too high.
Products are too near to
each other.
Store products so that
there is cold air circulation.
The appliance does
not operate.
The appliance is switched off.
Switch on the appliance.
The mains plug is not
connected to the mains
socket correctly.
Connect the mains plug to
the mains socket correctly.
The appliance has no
power. There is no voltage
in the mains socket.
Connect a different
electrical appliance to
the mains socket. Contact
a qualied electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing
the lamp".
If your appliance is still not working properly after making the above checks, contact the
After Sales Centre.
8.1 Replacing the lamp
This appliance is equipped with
a longlife LED interior light.
Only service is allowed to replace the
control unit. Contact your Service Center.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
“Installation”.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
02 12 2013_Electrolux -Rex UM_1.indb 70 2015-09-22 15:39:55
Page view 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 153 154

Comments to this Manuals

No comments